Universal Motor Start Module DMS05U

UNIVERSAL DIGITAL MOTOR STARTER
DMS05U  NOT AVAILABLE SEE BELOW

 Original vendor not available for this product.  Please substitute :

Electronic Motor Start Switch ECS224L

Price: $27.00   

Centrifugal Switch for Capacitor Start & Run Induction Motors .5 - 6.0 HP 208-240 VAC

or

Electronic Centrifugal Switch for Capacitor Start & Run Induction Motors .5 - 3.0 HP 120 VAC

Electronic Motor Start Switch ECS124L

Price: $33.25

NEW ELECTRONIC CENTRIFUGAL SWITCH FOR
ANY SINGLE PHASE MOTOR
UP TO 5 HP 110/240 VAC, 50/60 Hz

The smart replacement for any centrifugal switch used on any motor type, voltage, power, rpm and frequency! No more headaches having to figure out which switch to use!!

• The DMS05U module works on any single phase motor up to 5 hp.
• Every startup time is mathematically calculated for function of the motor type, voltage, and loading condition.
• Problems associated with rpm tolerance, mechanic and electrical fatigue, vibration, humidity, dust, and more are eliminated avoiding poor motor startups.
• If a motor is locked at startup for more than 0.5 seconds the modules’ start circuit opens and will not restart until the motor lockup is fixed, this avoids motor overheating or burn out,
• Installs easily in any motor.
• Body dimensions: 1.5” wide x 2.375” long x .78” thick
• Includes wiring diagrams for various motor types and voltages.

Module Terminals

L.= The line which the start capacitor (CS) close/open circuit is made.

C.= Where the free end of the start capacitor (CS) is wired.  The DMS05U close/open the terminals C & L during startup.

A.= Connected to the start capacitor (CS) and start winding

N.= Line in which the start winding is referenced.

Terminals L and N are your lines. Terminal C goes directly to the start capacitor. Terminal A connects between the start winding and the start capacitor (see wiring diagrams).